Internet Engineering Task Force (IETF)                       C. Holmberg
Request for Comments: 8035                                      Ericsson
Updates: 5761                                              November 2016
Category: Standards Track
ISSN: 2070-1721


     Session Description Protocol (SDP) Offer/Answer Clarifications
                       for RTP/RTCP Multiplexing

Abstract

   This document updates RFC 5761 by clarifying the SDP offer/answer
   negotiation of RTP and RTP Control Protocol (RTCP) multiplexing.  It
   makes it clear that an answerer can only include an "a=rtcp-mux"
   attribute in a Session Description Protocol (SDP) answer if the
   associated SDP offer contained the attribute.

Status of This Memo

   This is an Internet Standards Track document.

   This document is a product of the Internet Engineering Task Force
   (IETF).  It represents the consensus of the IETF community.  It has
   received public review and has been approved for publication by the
   Internet Engineering Steering Group (IESG).  Further information on
   Internet Standards is available in Section 2 of RFC 7841.

   Information about the current status of this document, any errata,
   and how to provide feedback on it may be obtained at
   http://www.rfc-editor.org/info/rfc8035.




















Holmberg                     Standards Track                    [Page 1]


RFC 8035               RTP/RTCP Mux Clarifications         November 2016


Copyright Notice

   Copyright (c) 2016 IETF Trust and the persons identified as the
   document authors.  All rights reserved.

   This document is subject to BCP 78 and the IETF Trust's Legal
   Provisions Relating to IETF Documents
   (http://trustee.ietf.org/license-info) in effect on the date of
   publication of this document.  Please review these documents
   carefully, as they describe your rights and restrictions with respect
   to this document.  Code Components extracted from this document must
   include Simplified BSD License text as described in Section 4.e of
   the Trust Legal Provisions and are provided without warranty as
   described in the Simplified BSD License.

   This document may contain material from IETF Documents or IETF
   Contributions published or made publicly available before November
   10, 2008.  The person(s) controlling the copyright in some of this
   material may not have granted the IETF Trust the right to allow
   modifications of such material outside the IETF Standards Process.
   Without obtaining an adequate license from the person(s) controlling
   the copyright in such materials, this document may not be modified
   outside the IETF Standards Process, and derivative works of it may
   not be created outside the IETF Standards Process, except to format
   it for publication as an RFC or to translate it into languages other
   than English.

























Holmberg                     Standards Track                    [Page 2]


RFC 8035               RTP/RTCP Mux Clarifications         November 2016


Table of Contents

   1.  Introduction  . . . . . . . . . . . . . . . . . . . . . . . .   3
   2.  Conventions . . . . . . . . . . . . . . . . . . . . . . . . .   3
   3.  Update to RFC 5761  . . . . . . . . . . . . . . . . . . . . .   3
     3.1.  Update to Section 5.1.1 . . . . . . . . . . . . . . . . .   4
   4.  Security Considerations . . . . . . . . . . . . . . . . . . .   6
   5.  IANA Considerations . . . . . . . . . . . . . . . . . . . . .   6
   6.  Normative References  . . . . . . . . . . . . . . . . . . . .   6
   Acknowledgements  . . . . . . . . . . . . . . . . . . . . . . . .   6
   Author's Address  . . . . . . . . . . . . . . . . . . . . . . . .   7

1.  Introduction

   RFC 5761 [RFC5761] specifies how to multiplex RTP data packets and
   RTP Control Protocol (RTCP) packets on a single UDP port, and how to
   negotiate usage of such multiplexing using the SDP offer/answer
   mechanism [RFC3264] with an "a=rtcp-mux" attribute.  However, the
   text is unclear on whether an answerer is allowed to include the
   attribute in an answer even if the associated offer did not contain
   an attribute.

   This document updates RFC 5761 [RFC5761] by clarifying that an
   answerer can only include an "a=rtcp-mux" attribute in an answer if
   the associated offer contained the attribute.  It also clarifies that
   the negotiation of RTP and RTCP multiplexing is for usage in both
   directions.

2.  Conventions

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in [RFC2119].

3.  Update to RFC 5761

   This section updates Section 5.1.1 of RFC 5761 by clarifying that an
   answerer can only include an "a=rtcp-mux" attribute in an answer if
   the associated offer contained the attribute, and by clarifying that
   the negotiation of RTP and RTCP multiplexing is for usage in both
   directions.










Holmberg                     Standards Track                    [Page 3]


RFC 8035               RTP/RTCP Mux Clarifications         November 2016


3.1.  Update to Section 5.1.1

   In this section, any references to Sections 4 and 8 are to those
   sections in [RFC5761].

   OLD TEXT:

   When the Session Description Protocol (SDP) [8] is used to negotiate
   RTP sessions following the offer/answer model [9], the "a=rtcp-mux"
   attribute (see Section 8) indicates the desire to multiplex RTP and
   RTCP onto a single port.  The initial SDP offer MUST include this
   attribute at the media level to request multiplexing of RTP and RTCP
   on a single port.  For example:

       v=0
       o=csp 1153134164 1153134164 IN IP6 2001:DB8::211:24ff:fea3:7a2e
       s=-
       c=IN IP6 2001:DB8::211:24ff:fea3:7a2e
       t=1153134164 1153137764
       m=audio 49170 RTP/AVP 97
       a=rtpmap:97 iLBC/8000
       a=rtcp-mux

   This offer denotes a unicast voice-over-IP session using the RTP/AVP
   profile with iLBC coding.  The answerer is requested to send both RTP
   and RTCP to port 49170 on IPv6 address 2001:DB8::211:24ff:fea3:7a2e.

   If the answerer wishes to multiplex RTP and RTCP onto a single port,
   it MUST include a media-level "a=rtcp-mux" attribute in the answer.
   The RTP payload types used in the answer MUST conform to the rules in
   Section 4.

   If the answer does not contain an "a=rtcp-mux" attribute, the offerer
   MUST NOT multiplex RTP and RTCP packets on a single port.  Instead,
   it should send and receive RTCP on a port allocated according to the
   usual port-selection rules (either the port pair, or a signalled port
   if the "a=rtcp:" attribute [10] is also included).  This will occur
   when talking to a peer that does not understand the "a=rtcp-mux"
   attribute.

   When SDP is used in a declarative manner, the presence of an
   "a=rtcp-mux" attribute signals that the sender will multiplex RTP and
   RTCP on the same port.  The receiver MUST be prepared to receive RTCP
   packets on the RTP port, and any resource reservation needs to be
   made including the RTCP bandwidth.






Holmberg                     Standards Track                    [Page 4]


RFC 8035               RTP/RTCP Mux Clarifications         November 2016


   NEW TEXT:

   When the Session Description Protocol (SDP) [8] is used to negotiate
   RTP sessions following the offer/answer model [9], the "a=rtcp-mux"
   attribute (see Section 8) indicates the desire to multiplex RTP and
   RTCP onto a single port, and the usage is always negotiated for both
   directions.

   If the offerer wishes to multiplex RTP and RTCP onto a single port,
   the initial SDP offer MUST include the attribute at the media level
   to request multiplexing of RTP and RTCP on a single port.  For
   example:

        v=0
        o=csp 1153134164 1153134164 IN IP6 2001:DB8::211:24ff:fea3:7a2e
        s=-
        c=IN IP6 2001:DB8::211:24ff:fea3:7a2e
        t=1153134164 1153137764
        m=audio 49170 RTP/AVP 97
        a=rtpmap:97 iLBC/8000
        a=rtcp-mux

   This offer denotes a unicast voice-over-IP session using the RTP/AVP
   profile with Internet Low Bit Rate Codec (iLBC) coding.  The answerer
   is requested to send both RTP and RTCP to port 49170 on IPv6 address
   2001:DB8::211:24ff:fea3:7a2e.

   If the offer contains the "a=rtcp-mux" attribute, and if the answerer
   wishes to multiplex RTP and RTCP onto a single port, it MUST include
   a media-level "a=rtcp-mux" attribute in the answer.  The RTP payload
   types used in the answer MUST conform to the rules in Section 4.  If
   the offer does not contain the "a=rtcp-mux" attribute, the answerer
   MUST NOT include an "a=rtcp-mux" attribute in the answer, and the
   answerer MUST NOT multiplex RTP and RTCP packets on a single port.

   If the answer contains an "a=rtcp-mux" attribute, the offerer and
   answerer MUST multiplex RTP and RTCP packets on a single port.

   If the answer does not contain an "a=rtcp-mux" attribute, the offerer
   and answerer MUST NOT multiplex RTP and RTCP packets on a single
   port.  Instead, they should send and receive RTCP on a port allocated
   according to the usual port-selection rules (either the port pair, or
   a signalled port if the "a=rtcp:" attribute [10] is also included).
   This will occur when talking to a peer that does not understand the
   "a=rtcp-mux" attribute.






Holmberg                     Standards Track                    [Page 5]


RFC 8035               RTP/RTCP Mux Clarifications         November 2016


   When SDP is used in a declarative manner, the presence of an "a=rtcp-
   mux" attribute signals that the sender will multiplex RTP and RTCP on
   the same port.  The receiver MUST be prepared to receive RTCP packets
   on the RTP port, and any resource reservation needs to be made
   including the RTCP bandwidth.

4.  Security Considerations

   The security considerations for RTP and RTCP multiplexing are
   described in RFC 5761.  This specification does not impact those
   security considerations.

5.  IANA Considerations

   IANA has added a reference to this document for the att-field (media
   level only) registration "rtcp-mux" in the "Session Description
   Protocol (SDP) Parameters" registry.

6.  Normative References

   [RFC2119]  Bradner, S., "Key words for use in RFCs to Indicate
              Requirement Levels", BCP 14, RFC 2119,
              DOI 10.17487/RFC2119, March 1997,
              <http://www.rfc-editor.org/info/rfc2119>.

   [RFC3264]  Rosenberg, J. and H. Schulzrinne, "An Offer/Answer Model
              with Session Description Protocol (SDP)", RFC 3264,
              DOI 10.17487/RFC3264, June 2002,
              <http://www.rfc-editor.org/info/rfc3264>.

   [RFC5761]  Perkins, C. and M. Westerlund, "Multiplexing RTP Data and
              Control Packets on a Single Port", RFC 5761,
              DOI 10.17487/RFC5761, April 2010,
              <http://www.rfc-editor.org/info/rfc5761>.

Acknowledgements

   Thanks to Colin Perkins, Magnus Westerlund, Paul Kyzivat, and Roni
   Even for providing comments on the document.  Thomas Belling provided
   useful input in the discussions that took place in 3GPP and resulted
   in the submission of the document.  Elwyn Davies performed the
   Gen-ART review.  Rick Casarez performed the Ops-Dir review.  Alissa
   Cooper and Spencer Dawkins provided IESG review comments.








Holmberg                     Standards Track                    [Page 6]


RFC 8035               RTP/RTCP Mux Clarifications         November 2016


Author's Address

   Christer Holmberg
   Ericsson
   Hirsalantie 11
   Jorvas  02420
   Finland

   Email: christer.holmberg@ericsson.com










































Holmberg                     Standards Track                    [Page 7]